Personal Fall Arrest System Inspection Checklist

All personal fall arrest system components must be inspected before each use or at least semiannually.

Personal fall arrest system inspection checklist.

Inspection and maintenance checklist for fall arrest warnings. Fall arrest system inspection checklist before use. A safety harness inspection also known as a fall protection harness inspection is a pre use check of personal fall arrest systems to determine if it is safe for use. Systems must be set up so that a worker cannot fall more.

Personal fall arrest system checklist source. Personal fall arrest system inspection checklist personal fall arrest systems must be inspected before each use. Includes d rings buckles keepers and back pads. Notify your supervisor and take the equipment out of service immediately.

Equipment out of service immediately. All fall arrest system components must be inspected before each use. Notify your supervisor and take the. Construction safety health fall hazards central new york cosh 2007 osha grant product personal fall arrest systems are one way to protect workers on construction sites where there are vertical drops of 6 or more feet.

Workers at heights such as building maintenance personnel electrical engineers and construction workers should assess the labeling webbing stitching d rings lanyards and. Stop use product recall. 3m dbi sala self rescue descent systems p n 3320030 31 37 inspection checklist form your safety while working at height depends on effective inspection of your fall protection equipment before and after use. What to look for accepted rejected full body harness hardware.

Osha standards 29 cfr part 1910 subpart f specifically address inspection requirements. Inspections personal fall arrest systems shall be inspected prior to use for mildew wear damage and other deterioration and defective components shall be removed from service if their strength or function may be adversely affected. Constitutes a failed inspection item. All fall protection equipment should be inspected prior to each use.

Do not use the equipment if any component fails inspection. If the personal fall arrest system meets the criteria and protocols in appendix d of this subpart and is being used by an employee having a combined body and tool weight of less than 310 pounds 140 kg the system is considered to be in compliance with the provisions of paragraphs d 1 i through iii of this section. Always read all instructions and warnings contained on the product and packaging before using any fall protection equipment.